They look like air bubbles to me, but it is weird they only come out after the bath. Could be they were already inside, but only covered by a thin wall of resin.

I usually use Isopropanol for bath not Ethanol, so I am not sure how your resin reacts with that. The bath should also be rather short, like 1min or something.

A few things to try:

• If you are shaking your resin before print, then give it like 10 minutes after you pour it into the vat, so all bubbles come out and pop
• lower the print speed
• add wait times between the end of lowering the plate and light on
• try to hollow out the model if possible, so there is less printing volume

My point was that if they would be trying to forge the results, they would likely write a better paper. Like, I have never seen nor would I use a phrase like:

Humankind has long learned that the properties of matter stem from its structure.

or

It is the superconductor with the same color as typical superconductors.

in the results section. It just reads like a student report.

So while it does not prove whether it is correct or not, it, at least in my understanding, indicates that it is genuine. The explanation might be off, the important step of the synthesis might include adding a teaspoon of luck, but the observations/measurements part I believe. Which is what I meant by the comment.

Climate Town tackled carbon capture very well in this video. In short, hardcore greenwashing.

https://www.youtube.com/watch?v=BwP2mSZpe0Q

Considering the two studies which claim that no effect was observed, I believe the original authors observed the effect but they don’t fully understand the origin.

The original paper is so naively unprofessional in some places that it is really hard for me to think it is not genuine.

say whaaaat. I wanna see it reproduced, but if true this is huge.